Rep 10.5 Exit 2 Transport Assembly - Xerox workcentre 5335 series Service Manual

4. Remove the Exit Sensor Plate Assembly
a. Remove the Screw (1).
b. Disconnect the connector.
b
Figure 3 Removing Screw
Replacement
1. To install, carry out the removal steps in reverse order.
Initial Issue
WorkCentre 5335 Family Service Documentation
(Figure 3).
a
BUS Updated 12/2011

REP 10.5 Exit 2 Transport Assembly

Parts List on PL 17.4
Removal
1. Switch off the power and disconnect the power cord.
2. Remove the following covers (Figure
a. Fax Cover.
b. Rear Upper Cover (2 Screws).
a
Figure 1 Removing Covers
3. Perform the following (Figure 2).
a. Open the Front Cover and the Left Hand Cover.
b. Remove the Xerographic Cartridge and the Toner Cartridge.
a
07/2011
4-85
1).
b
b
Figure 2 Removals
Repairs & Adjustments
REP 10.4, REP 10.5