Table of Contents
Advertisement
062-362 X Hard Fail RAP
BSD-ON:
BSD 3.3 - ESS-IIT Communication
Hard modification of authentication device was detected (at usual detection/power ON).
NOTE: When turning the power OFF, turn OFF the power switch first and then the main power
switch.
Procedure
•
Turn the power OFF and ON.
•
If the problem persists, reload the machine software
•
If the problem persists, turn the power OFF and replace the ESS PWB
Status Indicator RAPs
062-362, 062-371
(GP
16).
(PL
35.2).
07/2011
2-778
BUS Updated 12/2011
062-371 Lamp Illumination Fail RAP
BSD-ON:
BSD 6.1 - Document Illumination
BSD-ON:
BSD 6.6 - Image Input
Insufficient light from Lamp detected in CCD. (During white gradation correction/AGC before
Scan starts)
NOTE: When turning the power OFF, turn OFF the power switch first and then the main power
switch.
Initial Actions
Check the light path for any obstacle, and the lamp, the lens, the mirror and the White Correct-
ing Plate for deterioration or contamination.
Procedure
1.
Turn the power ON and enter the Diag mode. Change the value for NVM location [715-
030] to "1" and then execute "NVM Write".
2.
A 3 or 4-digit number is displayed in the current value column.
3.
Check the upper 1 or 2 digits, or the lower 2 digits using the following table and replace
the appropriate parts.
Sample Display
•
110 (3-digit display):
LED Lamp PWB failure and LED Lamp Flexible Flat Cable is damaged or has poor
contact.
(The first digit "1" in "110" is the upper digit, which indicates the LED Lamp PWB ("0"
in "01" is not displayed). The lower 2 digits "10" indicates the LED Lamp Flexible Flat
Cable.)
•
1000 (4-digit display):
The LED Lamp Flexible Flat Cable is damaged or has poor contact.
(The first 2 digits "10" in "1000" are the upper digits, which indicates the LED Lamp
Flexible Flat Cable. The lower 2 digits "00" indicates that nothing is applicable (no
failures).)
Initial Issue
WorkCentre 5335 Family Service Documentation
Advertisement
Table of Contents
