Table of Contents
Advertisement
133-700 Staple/Punch Cancelled RAP
The Controller cancelled the Staple/Punch operation due to staple relationship with the print
paper, or during data format processing for fax receive document printing in the Controller.
Staple/Punch request is canceled to continue printing.
Procedure
Change Staple/Punch position designation or select paper according to Staple/Punch position.
Initial Issue
WorkCentre 5335 Family Service Documentation
133-710 Tray Select Fail RAP
When printing Fax-received documents, it was performed via the Bypass tray since the
selected tray cannot be used for Fax.
The "Receiving Paper Size Tray Mode Function" is provided to determine "Which tray to
print the Fax-received data from". This error can occur when this function is "enabled."
Even if this function is "disabled," this error can also occur when printing Fax reports and
documents for polling.
* When set to automatically print Fax/Internet FAX received documents, this machine
automatically selects a paper tray. During that selection, any of the following occurs.
–
Since the selected tray is set as "Unavailable for Fax document print", the machine
selects the Bypass tray to continue printing.
–
Since the paper size in the selected tray is set as a size that cannot be used for Fax,
the machine selects the Bypass tray to continue printing.
–
Since the paper type (= paper quality) in the selected tray is set as a quality that
cannot be used for Fax, the machine selects the Bypass tray to continue printing.
–
If none of the above applies, the selected tray might be malfunctioning.
* This error also occurs when any of the four conditions above is detected when "the
customer selects the Bypass tray and tries to print from a mailbox".
Procedure
•
Load the paper size that can be used for Fax printing.
A3SEF, A4LEF, B4SEF, B5LEF, A4SEF, A5SEF, B5SEF, Letter SEF, Legal (14inch), Legal
(13inch), Ledger, Letter LEF, and Half Letter SEF can be used.
•
Load the paper type (= paper quality) that can be used for Fax printing.
Plain Paper, Bond Paper, Recycled Paper, Backing Paper, and Custom Paper can be
used.
•
When the machine is set to "Enable Receiving Paper Size Tray Mode Function", perform
any one of the following:
Select [Settings List] → [Fax Control] → [Tray Mode] to add the tray number that the
1.
customer wants to specify for printing.
2.
Select a tray number for the customer's printing use from the one of the trays that
are set in [Settings List] → [Fax Control] → [Tray Mode].
Instead of selecting [Settings List] → [Fax Control] → [Tray Mode], the same settings can be
performed through [System Data: 820-002] → [Tray selection in tray mode].
If the problem persists, perform the following procedure to repair it. Check the sw version of the
controller sw - update if required
07/2011
2-1007
BUS Updated 12/2011
Status Indicator RAPs
133-700 , 133-710
Advertisement
Table of Contents
