Rep 10.2 Duplex Sensor - Xerox workcentre 5335 series Service Manual

6. Remove the Duplex Assembly from the Left Hand Cover (4 Screws)
Figure 5 Removing Screws
7. Remove the Duplex Motor (2 Screws)
Figure 6 Removing Screws
Replacement
1. To install, carry out the removal steps in reverse order.
Repairs & Adjustments
REP 10.1, REP 10.2
(Figure 5).
6
(Figure 6).
7
BUS Updated 12/2011

REP 10.2 Duplex Sensor

Parts List on PL 14.4
Removal
1. Switch off the power and disconnect the power cord.
2. Open the Left Hand Cover (Figure
a. Release the front and rear locking tabs and remove the BTR Assembly.
3. Remove the Left Hand Chute Cover (4 Screws)
Figure 2 Removing Screws
07/2011
4-82
1).
Figure 1 Removal
(Figure 2).
3
WorkCentre 5335 Family Service Documentation
a
Initial Issue