024-968 Stapler/Punch Concurrence Rap; 024-969 Different Width Mix Punch Rap - Xerox workcentre 5335 series Service Manual

024-968 Stapler/Punch Concurrence RAP

BSD-ON: BSD 12.15 - Office Finisher LX Punch
Staple position and Punch position are the same.
Initial Actions
• Check if there is the specified paper in the tray.
• Switch the power OFF then ON.
Procedure
Cancel Staple mode and Punch mode. The same problem recurs.
Y N
Correct the settings.
Check the connection of each connector of the Finisher PWB. The connectors are properly
connected.
Y N
Connect the connectors properly.
Check the connection of the cable between the machine and the Finisher. The cable is prop-
erly connected.
Y N
Connect the cable properly.
Replace the Finisher PWB (PL 23.16).
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - update if required
Initial Issue
WorkCentre 5335 Family Service Documentation

024-969 Different Width Mix Punch RAP

BSD-ON: BSD 12.15 - Office Finisher LX Punch
Different Width Mix Punch. Paper of different widths was detected while printing in punch
mode.
Initial Actions
• Check if there is the specified paper in the tray.
• Switch the power OFF then ON.
Procedure
Copy: Cancel Punch mode (user intervention) Printer: Cancel Punch mode (auto cancella-
tion) The same problem recurs.
Y N
Correct the settings.
Check the connection of each connector of the Finisher PWB. The connectors are properly
connected.
Y N
Connect the connectors properly.
Check the connection of the cable between the machine and the Finisher. The cable is prop-
erly connected.
Y N
Connect the cable properly.
• Replace the Finisher PWB
(PL 18.2).
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - update if required
07/2011
2-423
BUS Updated 12/2011
(PL 23.16), if the problem continues, replace the MCU PWB
Status Indicator RAPs
024-968, 024-969