016-351 Ess Eeprom Diag Failure 2 Rap; 016-360 Cont Ui Fail-1 Rap - Xerox workcentre 5335 series Service Manual

016-351 ESS EEPROM DIAG Failure 2 RAP

BSD-ON: BSD 16.1 - ESS
Read/Write/Verify error for the ESS EEPROM.
Initial Actions
Power Off/On.
Procedure
1. Check connections between the following components:
• ESS EEPROM and ESS PWB (check for bent pins etc.)
2. Check the sw version of the controller sw - update if required
3. If problem persists replace ESS PWB.
Initial Issue
WorkCentre 5335 Family Service Documentation
(PL 35.2).
PL 35.3.
BUS Updated 12/2011

016-360 Cont UI Fail-1 RAP

BSD-ON: BSD 16.1 - ESS
Cont UI Diagnostic Fail-1. An error occurred during W/R/V test of PCI Config interval.
Procedure
Turn the power OFF then ON. If the problem persists, perform the following:
1. Remove and re-install the UI I/F PWB
2. Check the sw version of the controller sw - update if required
3. If problem persists replace ESS PWB.
4. Replace the UI I/F PWB (PL
5. Replace the ESS PWB (PL
07/2011
2-165
(PL 1.7).
PL 35.3.
1.7).
35.2).
Status Indicator RAPs
016-351, 016-360