Paper Jam 2 Check Inside Rap; No Paper Add Paper Rap - Xerox WorkCentre M20 Service Manual

8.6 Paper Jam 2 Check Inside RAP

The machine has detected paper at the output sensor.
Procedure
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
WARNING
Do not touch the fuser while it is hot.
NOTE: If necessary, refer to GP 20 for the acronym list and cross reference lists of more com-
monly recognised part names.
Refer to Wiring Diagram 3. Perform the following:
1. Remove all of the jammed paper from the exit area.
2. Open the right hand cover. Remove all paper.
3. Check that the paper path is clear.
4. Enter GP 1 Engine Test Mode Entry. Use the sensor test to check OB. This is the PBA
SUB - bin full sensor, PL 10.10 Item 20.
5. Enter GP 1 Engine Test Mode Entry. Check that the motor step - MCK2 (main) (fuser
motor) runs. Install new components as necessary, PL 4.20.
6. If necessary, install a new PBA main, PL 1.10 Item 9.
Status Indicator RAPs
8.6, 8.7

8.7 No Paper Add Paper RAP

The machine does not detect paper in the paper tray.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
NOTE: If necessary, refer to GP 20 for the acronym list and cross reference lists of more com-
monly recognised part names.
Refer to Wiring Diagram 3. Perform the following:
1. Add paper to the paper tray.
2. If necessary, enter GP 1 Engine Test Mode Entry and check FE. This is the paper entry
sensor, part of the PBA SUB - feed & P.EMP SEN, PL 8.25 Item 12.
3. If necessary, install a new PBA main, PL 1.10 Item 9.
March 2004
2-8
WARNING
Work Centre M20 Family