Match Ip Access-Group - Dell Force10 Z9000 Reference Manual

qos-policy-output
wred-profile

match ip access-group

Configure match criteria for a class map, based on the access control list (ACL).
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax match ip access-group access-group-name [set-ip-dscp value]
To remove ACL match criteria from a class map, use the no match ip access-group
access-group-name [set-ip-dscp value] command.
Parameters
access-group-
name
set-ip-dscp
Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command History
Version 8.3.11.1
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Usage You must enter the class-map command in order to access this command. After the class
Information map is identified, you can configure the match criteria. For class-map match-any, a maximum
of five ACL match criteria are allowed. For class-map match-all, only one ACL match
criteria is allowed.
Related
class-map
Commands
1196
– creates an output QoS-policy on the router.
– creates a WRED profile.
Enter the ACL name whose contents are used as the match criteria in
determining if packets belong to the class specified by class-map.
value
(OPTIONAL) Enter the keywords set-ip-dscp followed by the IP
DSCP value. The matched traffic is marked with the DSCP value. The
range is 0 to 63.
Introduced on the Z9000.
Introduced on the Z9000.
Introduced on the S4810.
Added the DSCP Marking option support on the S-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Added support for the DSCP Marking option.
Introduced on the E-Series.
– identifies the class map.