Avaya S8700 Maintenance Manual page 2134

Maintenance-Object Repair Procedures
Table 8-568. TEST #760 Processor Route Audit Test — Continued
Error Test
Code Result Description / Recommendation
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
FAIL If this test fails, one or more administered circuit packs in this switch node
carrier did not respond with a "board insertion" uplink message. Verify that
administered SNI and SNC boards match the physically installed SNI and SNC
boards by entering list config carrier UUC. The command output will show
"NO BOARD" for every board that is administered, but not inserted.
PASS If this test passes, every administered circuit pack in this switch node carrier
was inserted.
0 NO No board was detected by the test.
BOARD
1. Check that SNC board is properly translated and inserted.
2. Run the test again. If it fails, reset the board. An SNC should be reset
3. Run the test again. If it fails, the ID chip on board may be bad. Replace
8-1412 Issue 1 May 2002
If every administered board is inserted, run this test again.
If administration does not match the physical configuration, and is
correct, insert the missing circuit packs in this switch node carrier.
If none of the administered boards in this switch node carrier were
inserted, fix any other SN-CONF errors by following the associated
repair procedures for SN-CONF. Use display errors with category
pnc to view SN-CONF errors. Next check if any INLs, LNLs, or
RNLs are down, see
''SYS-LINK (System Links)''
problems.
instead of reseating the circuit pack. The reset board command should
almost never be used on an SNC. It may be necessary to use the reset
board command if the SNC circuit pack gets into a mode where it cannot
communicate with software. If an SNC with active errors and alarms is
reset, the errors and alarms may take a while to come back, therefore the
reset board command can mask real problems.
the board and retest.
for fixing link
Continued on next page
555-233-143