Honda ACCORD HYBRID 2005 Service Manual page 1919

Calibration
NOTE: This procedure must be done after the
temperature sensor stabilizes.
The outside air temperature indicator's displayed
temperature can be recalibrated ± 3 ° to meet the
customer's expectations.
1. Turn the ignition switch ON (II).
2. Press and hold the reset select button for 10
seconds. While y o u continue to hold the button, the
display will scroll t h r o u g h temperature settings
f r o m + 3 ° to —3 ° as s h o w n .
3. W h e n the desired correction value appears on the
display, release the button, and the recalibrated
outside air temperature will be displayed.
Each t i m e a desired correction valve is entered, it
replaces the previous valve.
Example:
Incorrect value = 68 °F (20 °C)
Desired correction valve = + 2 °F (+1 °C)
Correct valve = 70 °F (21 °C)
Desired correction valve = —2 °F (—1 °C)
Correct valve = 66 °F (19 °C)
NOTE: To recalibrate the display to the true
temperature, remove the outside air temperature
sensor (A), but leave it connected. Submerge the
sensor and a t h e r m o m e t e r (B) in a container of ice
water (C). Select the calibration mode as described
above, then recalibrate the display to the true
temperature.
R e s e t t i n g t h e M a i n t e n a n c e
R e q u i r e d I n d i c a t o r
Blinking Pattern:
Miles (km) Maintenance Reminder Light
At 7,900 (12,640) to
8,100 (12,960)
Blinks for 10 seconds w h e n the
ignition switch is turned ON (II).
At 9,900 (15,840) to
11,000 (16,160)
Comes on and stays on w h i l e
the ignition switch is ON (II).
How to Reset
Push and hold the trip/reset button, turn the ignition
switch ON (II), and continue to hold the button for more
than 10 seconds.
22-237