Honda ACCORD HYBRID 2005 Service Manual page 1774

Multiplex Integrated Control System (MICS)
T r o u b l e s h o o t i n g - B - C A N S y s t e m D i a g n o s i s T e s t M o d e 1 a n d T e s t M o d e 2
( w i t h o u t t h e H D S ) ( c o n t ' d )
How to display DTC on the gauge control module
1. W h i l e in Test Mode 1, the DTCs w h i c h have been detected and stored individually by various B-CAN (Body-
controller Area Network) units, w i l l be s h o w n one by one on the ODO display w h e n the c o m m u n i c a t i o n between
the Multiplex Integrated Control Unit (MICU) and the gauge control module is n o r m a l . To scroll t h r o u g h the DTCs,
press the RESET knob on the gauge control m o d u l e .
Displaying the DTC.
The lower four digits is a decimal
number representing the DTC.
- No DTCs detected.
^ All the DTCs have been displayed.
MICU 10
Relay Control Module
11
Door Multiplex Control Unit
30
Gauge Control Module
50
Climate Control Module 51
Combination Switch Control Unit 70
How to clear the DTC
1. W h i l e in Test Mode 1, press and hold d o w n the RESET knob for more than 10 seconds.
2. The unit that has stored the code can be identified by the n u m b e r s h o w n on the trip display.
22-92