Honda ACCORD HYBRID 2005 Service Manual page 1900

Wipers/Washers
D T C T r o u b l e s h o o t i n g ( c o n t ' d )
DTC B1281: Windshield Wiper Switch MIST
Position Circuit Malfunction
DTC B1282: Windshield Wiper Switch INT
(AUTO) Position Circuit Malfunction
DTC B1283: Windshield Wiper Switch LOW
Position Circuit Malfunction
DTC B1284: Windshield Wiper Switch HIGH
Position Circuit Malfunction
1. Clear the DTCs using the HDS.
2. Cycle the ignition switch to OFF and then back
ON (II).
3. Turn the windshield w i p e r switch in MIST and w a i t
for 2 seconds.
4. Turn the windshield w i p e r switch OFF and w a i t for
2 seconds.
5. Turn the windshield w i p e r switch in INT (AUTO)
and wait for 2 seconds.
6. T u r n the w i n d s h i e l d w i p e r switch in LOW and w a i t
for 2 seconds.
7. Turn the windshield w i p e r switch in HIGH and w a i t
for 2 seconds.
8. Check for DTCs using the HDS.
Is DTC B1281, 31282, B1283, or B1284 indicated?
YES—Replace the w i n d s h i e l d wiper/washer
switch. •
NO—Intermittent failure, the w i n d s h i e l d
wiper/washer switch and the c o m b i n a t i o n switch
control unit are OK at this t i m e . Check pinfits and
connections. •
W i p e r / W a s h e r S w i t c h T e s t /
R e p l a c e m e n t
NOTE: The wiper/washer switch is built into the
c o m b i n a t i o n switch control unit. For the wiper/washer
test, refer to the wiper/washer switch input test
(see page 22-219).
1. Remove the dashboard lower cover (see page
20-67).
2. Remove the steering c o l u m n covers (see page
17-9).
3. Disconnect the c o m b i n a t i o n light switch 12P
connector (A) and dashboard w i r e harness 8P
connector (B) f r o m the wiper/washer switch (C).
B
C
4. Remove the t w o screws, then slide out the
wiper/washer switch.
22-218