Honda ACCORD HYBRID 2005 Service Manual page 1669

H I
R e c e i v e r / D r y e r D e s i c c a n t
R e p l a c e m e n t
NOTE: Install the receiver/dryer as quickly as possible
to prevent the system f r o m absorbing moisture f r o m
the air.
1. Remove the A/C condenser (see page 21-97).
2. Remove the bolts f r o m the A/C condenser, then
remove the receiver/dryer (A), the bracket (B), and
the O-rings (C).
C
3. Install the receiver/dryer in the reverse order of
removal, and note these items:
Replace the O-rings w i t h new ones, and apply a
thin coat of only r e c o m m e n d e d polyol ester (POE)
refrigerant oil (SANDEN SE-10Y) before installing
t h e m . Be sure to use the correct O-rings for
HFC-134a (R-134a) to avoid leakage.
Using the w r o n g refrigerant oil can be a safety
hazard (see page 21-6).
A / C C o m p r e s s o r D r i v e r
R e p l a c e m e n t
NOTE: Put on gloves to protect your hands.
IMA c o m p o n e n t s are located in this area. The IMA is a
high-voltage system. You must be familiar w i t h the IMA
system before w o r k i n g on or around it. Make sure y o u
have read the IMA service precaution before doing
repairs or service (see page 12-3).
1. Remove the IPU lid (see page 12-140).
2. Disconnect the A/C compressor power cables (A)
f r o m the terminal stay, then w r a p t h e m w i t h
insulating tape (B).
NOTE: Check the position of the U phase, V phase,
and W phase cables before disconnecting the A/C
compressor motor power cables.
3. Disconnect A/C compressor driver connector (A),
and wires (B).
9.8 N m
(1.0 k g f m , 7.2 Ibf-ft)
4. Remove the A/C compressor driver (C).
5. Install the parts in the reverse order of removal.
21-99