Honda ACCORD HYBRID 2005 Service Manual page 1795

DTC B1102: Door Multiplex Control Unit
Internal Error
1. Clear the DTCs using the HDS.
2. Cycle the ignition switch to OFF and then back O N .
3. Operate the power w i n d o w (UP/DOWN).
4. Check for DTCs using the HDS.
lsDTCB1102 indicated?
YES—Faulty door multiplex control unit; replace
the power w i n d o w master switch. •
NO—Intermittent failure, the door multiplex control
unit is OK at this t i m e . Check for loose or poor
connections. If the connections are g o o d , check the
battery condition (see page 22-71) and the charging
system. •
DTC B1178: F-CAN Communication Line Error
DTC B1168: Gauge Control Module Lost
Communication with PCM (Engine
Messages)
DTC B1169: Gauge Control Module Lost
Communication with the PCM (A/T
Messages)
1. Clear the DTCs using the HDS.
2. Turn the ignition switch OFF then back to the ON (II).
3. Start and run the engine for at least 5 seconds then
turn the engine off.
4. Check for DTCs using the HDS.
Is DTC B1178,B1168 and/or B1169 indicated?
Y E S — G o t o step 5.
NO—Intermittent failure, the F-CAN
c o m m u n i c a t i o n line is OK at this t i m e . Check for
loose or poor connections. If the connections are
g o o d , check the battery condition (see page 22-71)
and the charging system. •
5. Check for DTCs in the PCM, ABS/TCS or Navigation.
Are any DTCs indicated?
YES—Troubleshoot the PCM, ABS/TCS or
Navigation DTCs.B
NO—Go to step 6.
(cont'd)
22-113