Honda ACCORD HYBRID 2005 Service Manual page 1750

Under-hood Fuse/Relay Box
R e m o v a l a n d I n s t a l l a t i o n
Removal
1. Make sure you have the anti-theft codes for the
radio and the navigation system, then write d o w n
the customer's audio presets.
2. Connect the HDS to the data link connector (DLC),
and ground the SCS.
3. Disconnect the battery negative cable, then
disconnect the positive cable, and wait at least
3 minutes.
4. Remove the under-hood multi-relay box (Canada)
f r o m the under-hood fuse/relay box.
5. Remove the screws (A) f r o m the alternator and
battery cable terminals.
6. Remove the t w o m o u n t i n g bolts (B) f r o m the
under-hood fuse/reley box.
7. Remove the under cover f r o m the under-hood fuse/
reley box.
8. Disconnect the connectors f r o m the under-hood
fuse/reley box.
Installation
1. Connect the connectors to the under-hood fuse/
relay box, then install the under-hood fuse/relay
box in the reverse order of removal.
2. Install the removed parts in the reverse order of
removal.
3. Connect the both positive cable and negative cable
to the battery.
4. Do the PCM idle learn procedure (see page 11-340).
5. Reset the power w i n d o w control unit (see page
22-200).
6. Enter the anti-theft codes for the radio and
navigation system, then enter the customer's audio
station presets.
7. If the IMA battery level gauge (BAT) displays no
segments, start the engine, and hold it between
3,500 r p m and 4,000 r p m w i t h o u t load (in Park or
neutral) until the BAT displays at least three
segments.
8. Confirm that all systems w o r k properly.
22-68