Exterior Trim
S i d e S i l l P a n e l R e p l a c e m e n t
1. Remove the side sill panel.
- 1 Remove the screws (A), clip (B), and if equipped, remove the splash guard (C).
- 2 Pull the inner fender (D) back as necessary, and remove the clips (E, F), fastening the side sill panel (G) and
the middle floor under cover (H).
- 3 Slide the side sill panel f o r w a r d , and remove it. The side clips (I) w i l l stay in the body.
- 4 Remove the side clips f r o m the body.
Fastener Locations
A •
: Screw, 3
B > : Clip, 1
E > : Clip, 2
F t> : Clip, 1
I > : Clip, 9
2. Replace any damaged clips.
3. Install the side clips on the side sill panel.
4. Hold the panel up, and fit all the side clips into the holes in the body, then push on the panel until the clips snap
into place.
5. Install all the clips.
6. Reinstall the inner fender and splash guard.
20-118