Honda ACCORD HYBRID 2005 Service Manual page 1659

H D
6. Remove the connector clip (A). Slide the hose
clamps (B) back. Remove the bolt and heater valve
bracket, then disconnect the inlet heater hose (C)
and the outlet heater hose (D) f r o m the heater unit.
Engine coolant w i l l run out w h e n the hoses are
disconnected; drain it into a clean drip pan. Be sure
not to let coolant spill on the electrical parts or the
painted surfaces. If any coolant spills, rinse it off
immediately.
7. Remove the m o u n t i n g nut f r o m the heater unit.
Take care not to damage or bend the fuel lines and
the brake lines, etc..
(1.2 k g f m , 9 Ibfft)
8. Remove the dashboard (see page 20-73).
9. Disconnect the connectors (A) f r o m the driver's air
mix control motor, the passenger's air mix control
motor, the evaporator temperature sensor, the
heater core sensor, the power transistor, and the
recirculation control motor, then remove the wire
harness clips (B), the connector clips (C) and the
w i r e harness (D). Remove the heater ducts (E), then
remove the m o u n t i n g nuts and the blower-heater
unit (F).
6 x 1.0 mm
9.8 N m
F (1.0 k g f m , 7.2 Ibfft)
10. Remove the self-tapping screws, then remove the
passenger's heater outlet (C), and the heater core
cover (D), and the heater core sensor (E). Remove
the self-tapping screws, the evaporator
temperature sensor (F) and the joint duct A, then
remove the self-tapping screws and the joint duct B.
Remove the self-tapping screws, the heater pipe
bracket (G), the g r o m m e t s (H), and carefully pull
out the heater core (I) so y o u d o n ' t bend the inlet
and outlet pipes.
(cont'd)
21-89