GS920 Series Gigabit Ehternet Switch Installation and User's Guide
Ethernet Port Configuration
Configuring All
Ports with the
Same Speed and
Duplex Settings
The AT-GS920 switch ports can be configured for the speed, duplex
mode, and MDI/MDIX settings. The ports can be configured all together or
individually. See Table 20 for more details.
Port Configuration
Speed and Duplex
Mode
MDI/MDIX
Perform the following procedure to set all of the ports to the same speed
and duplex configuration:
1. Set DIP switch # 6 (OPERATION/CONFIG) to the UP (CONFIG)
position.
The switch is now in the port configuration mode.
2. Set DIP switch # 7 (ALL/EACH) to the DOWN (ALL) position as shown
in Figure 53.
All of the port LEDs flash indicating that all of the ports are ready to be
configured.
Table 20. Port Configuration
Default Settings
100 Mbps in Half Duplex
Auto MDI/MDIX
Options
Auto Negotiation
1000M in Full
100M in Full
100M in Half
10 M in Full
10 M in Half
Auto MDI/MDIX
Force MDI/MDIX
84