Removing And Installing Drive Shaft - Seat Leon 2013 Workshop Manual

12 - Clamp
❑ Always renew after removing
❑ Tightening ⇒ page 136
13 - Adapter
14 - Joint body
❑ Removing ⇒ page 134
15 - Multi-point socket head bolt
❑ M10 x 23
❑ Initially tighten diagonally to 10 Nm and then tighten diagonally to specified torque.
❑ 70 Nm
16 - Joint body
❑ Removing ⇒ page 134
17 - Retaining ring
❑ Always renew after removing
❑ Insert in groove in shaft
6.3

Removing and installing drive shaft

⇒ "6.3.1 Removing and installing drive shaft, left drive shaft, con‐
stant velocity joints VL100 and VL107", page 103
⇒ "6.3.2 Removing and installing drive shaft, right drive shaft,
constant velocity joints VL100 and VL107", page 107
⇒ "6.3.3 Removing and installing drive shaft, triple roller joint
AAR3300i inserted", page 111
⇒ "6.3.4 Removing and installing drive shafts, triple roller joint
AAR3300i bolted", page 116
6.3.1 Removing and installing drive shaft, left
drive shaft, constant velocity joints
VL100 and VL107
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1332-
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
103
6. Drive shaft