Checking Adjustment Of Assembly Mountings; Adjusting Assembly Mounting - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Unscrew bolts -1, 2 and 3-, and remove pendulum support.
Installation
Installation is carried out in the reverse order. Please note the
following:
Note
There are threaded inserts (e.g. "Heli Coil") in the bolting holes
♦
for the pendulum support.
ID: bead shoulder threaded on the first rotation -Arrow-.
♦
Specified torques
♦ ⇒ Fig. ""Installing pendulum support"" , page 26
2.6 Checking adjustment of assembly
mountings
Work sequence
The following dimensions must be reached:
• There must be a distance of -a- = 10 mm between engine
support -2- and engine mounting -1-.
• The side surface of the engine support -2- should be located
parallel to the support arm of the engine mounting -1-.
• Distance -b- = distance -b-.
Note
For example, distance -a- = 10 mm can be checked with a metal
rod of suitable size.
– If the distance measured is too large or small, the assembly
mountings must be adjusted
2.7

Adjusting assembly mounting

Work sequence
– Support engine and gearbox in installation position
⇒ page 26 .
– Remove battery tray ⇒ Electrical system; Rep. gr. 27 ; Battery;
Removing and installing battery tray .
32
Rep. gr.10 - Removing and installing engine
⇒ page 32 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.