Removing And Installing High-Pressure Pipe - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
7.3 Removing and installing high-pressure
pipe
Special tools and workshop equipment required
♦ Torque wrench - VAS 6854-
♦ Tool set - T10395 A-
Removing
– Remove throttle valve control unit - GX3-
CAUTION
The fuel system is under high pressure.
Risk of injury due to fuel which may spurt out.
– Release high pressure.
– ⇒ "1.2 Reducing fuel pressure in high-pressure section", page
208
Note
Risk of functional impairment due to soiling.
♦
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
⇒ "3.1 Rules for cleanliness", page 4
♦
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
248
Rep. gr.24 - Mixture preparation - injection
⇒ page 232