Checking Charge Air System For Leaks - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Set drip tray for workshop hoist - VAS 6208- underneath.
– Clamp off coolant hoses at charge air cooler with hose clamps
-3094- .
– Loosen the hose clips -1-, remove the coolant hoses.
– Remove bolts -arrows-.
– Pull charge air cooler -1- evenly towards front (in
-direction of arrow-) out of intake manifold.
Installation
Installation is carried out in the reverse order. Please note the
following:
– Fit sealing lip -1- in -direction of arrow- onto charge air cooler
-2-.
– Insert new gasket into groove on intake manifold.
– Tighten bolts -arrows- alternately and diagonally working from
centre outwards.
– Install hose clips -1-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Note
If there are slight impressions on the fins, refer to
– Install radiator cowl
– Check coolant level
Specified torques
♦ ⇒ "2.1 Assembly overview - charge air system", page 197
♦ ⇒ Rep. gr. 87 ; Air conditioning compressor; Removing and
installing the air conditioner compressor in the bracket.
2.5

Checking charge air system for leaks

Special tools and workshop equipment required
202
Rep. gr.21 - Turbocharging/supercharging
⇒ page 187 .
⇒ page 155 .
⇒ page 6 .