Removing And Installing Subframe With Steering Rack - Seat Leon 2013 Workshop Manual

Note
Tighten nuts -arrows- in unladen state
– On vehicles with vehicle level sender, carry out basic setting
⇒ Vehicle diagnostic tester.
Specified torques
♦ ⇒ "2.1 Assembly overview - subframe", page 18
♦ ⇒ "3.1 Assembly overview - steering box", page 358
♦ Bolts for pendulum support ⇒ Rep. gr. 10 ; Assembly mount‐
ings; Assembly overview - assembly mountings
♦ Bolts for noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Assembly overview - noise in‐
sulation .
♦ Exhaust system to subframe ⇒ Rep. gr. 26 ; Exhaust pipes/
silencers; Assembly overview - silencer .
If even when using locating pins - T10486/1- a crooked steering
wheel is determined during the road test, carry out a wheel align‐
ment check. In this case the wheel alignment test results must be
archived in the vehicle files.
2.3 Removing and installing subframe with
steering rack
⇒ "2.3.1 Removing and installing subframe with steering rack, left-
hand drive vehicle", page 23
⇒ "2.3.2 Removing and installing subframe with steering rack,
right-hand drive vehicle", page 30
2.3.1 Removing and installing subframe with
steering rack, left-hand drive vehicle
Special tools and workshop equipment required
♦ Ball joint puller - T10187-
Running gear, axles, steering - Edition 06.2018
⇒ page 5 .
León 2013 ➤ , León ST 2013 ➤
23
2. Subframe