Removing And Installing Oil Spray Jet - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Compare width of Plastigage with the measurement scale.
• Radial clearance: 0.028 ... 0.065 mm
– Renew conrod bolts.
4.5

Removing and installing oil spray jet

Special tools and workshop equipment required
♦ Socket and key - T10545-
Removing
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Assembly overview - noise in‐
sulation .
– Remove sump
⇒ "1.3 Removing and installing sump", page 130
– Turn crankshaft via vibration damper securing bolt in direction
of engine rotation until the respective bolt is accessible.
– Unscrew pressure relief valve -1- using bit - T10545- .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
– Remove oil spray jets -2-.
respect to the correctness of information in this document. Copyright by SEAT S.A.
Installation
1 - Pressure relief valve, 27 Nm
2 - Oil spray jet
NOTICE
Risk of damage to oil spray jets.
– Do not bend oil spray jets.
– Check that oil spray jets adequate clearance after re-instal‐
ling pistons.
– Bent oil spray jets must be renewed.
• Installation position: align leading edge of oil spray jet with
machined surface of cylinder block.
– Install oil pan
⇒ "1.3 Removing and installing sump", page 130
– Install noise insulation ⇒ General body repairs, exterior; Rep.
gr. 66 ; Noise insulation; Assembly overview - noise insula‐
tion .
68
Rep. gr.13 - Crankshaft group
.
.