Removing And Installing Track Rod Ball Joint - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
– Tighten the new hose clip -1- using locking pliers for steering
rack - VAS 6199- .
– Tighten clamp so that its ear -arrow- is positioned as shown in
illustration.
– Install wheel and tighten.
– Align wheels of vehicle
– If both track rods have been exchanged, basic setting must be
carried out for steering angle sender - G85- ⇒ Vehicle diag‐
nostic tester.
– Then carry out basic setting of steering ⇒ Vehicle diagnostic
tester.
Specified torques
♦ ⇒ "3.1 Assembly overview - steering box", page 358
♦ ⇒ "3.6 Repairing steering box", page 385
3.5 Removing and installing track rod ball
joint
Special tools and workshop equipment required
♦ Ball joint puller - T10187-
♦ Torque wrench - V.A.G 1332-
Removing
– Remove front wheel on affected side.
384
Rep. gr.48 - Steering
⇒ page 299 .