Seat Driving Modes (Seat Drive Profile) - Seat LEON 2019 Owner's Manual

 It flashes yellow
The steering column is jammed.
When stopped, turn the steering wheel in both direc-
tions.
OR: The steering column does not unlock or lock.
Remove the key from the ignition switch and recon-
nect it. Consider the messages shown on the instru-
ment panel display.
Do not continue driving if the steering column re-
mains locked after switching on the ignition. Seek
specialist assistance.
The control lamp should light up for a few
seconds when the ignition is switched on. It
should go out once the engine is started.
WARNING
Never ignore the warning lamps or messag-
es.
If the warning lamps and the correspond-
●
ing messages are ignored, the vehicle may
stall in traffic, causing serious damage or
accidents and injuries.
Stop the vehicle at the next opportunity
●
and in a safe place.
1) In the Leon Cupra model, the Eco mode can be
selected through the Individual profile by setting
the engine characteristic to Eco.
Start and driving
SEAT Driving modes (SEAT
Drive Profile)*
Introduction
The SEAT Drive Profile enables the driver to
choose between the Eco , Normal , Sport and
profiles and modes, which modi-
Individual
fy the behaviour of various vehicle functions,
providing different driving experiences. In the
FR and X-PERIENCE models equipped with
dynamic chassis control (DCC), the Comfort
profile is also available.
In the Leon Cupra model the four profiles are
, Sport , Cupra and Individual .
Comfort
The Individual profile can be configured
according to personal preferences. The other
profiles have a fixed configuration.
Description
Depending on the equipment fitted in the ve-
hicle, SEAT Drive Profile can operate on the
following functions:
Engine
Depending on the profile selected, the engine
responds more quickly or smoothly to the ac-
celerator being pressed. When Eco mode is
selected, the Start-stop function is activated.
In vehicles with automatic transmission, the
gear change timing is changed to put the
changes at higher or lower revolutions. Eco
mode activates the Inertia function, thereby
reducing consumption. The rest of the driving
modes will activate the inertia use function
when the selector lever is not in the S posi-
tion, depending on how the accelerator ped-
›››
al is released page 261. When the vehicle
is turned on again, the function is activated
by default to reduce consumption.
With a manual gearbox, the Eco mode
changes the gear changes recommenda-
tions to facilitate more efficient driving.
Dynamic chassis control (DCC)
DCC continuously adapts the shock absorb-
ers to the condition of the road and current
driving conditions, according to the pre-set
programme.
In the event of a fault in the DCC, the follow-
ing message is displayed on the instrument
1)
»
265