Run The Ewire In Bind Mode - GBC eWire Service Manual

8.11.

Run the eWire in Bind Mode

Do the following to run the eWire in Bind Mode.
1. From the top level screen on the LCD User Interface, press either
the Up Arrow Button or the Down Arrow Button.
2. Do GP 6.2.5 to enter BIND mode.
3. READY – TO BIND should appear.
4. The EWire is now ready to function in BIND mode.
5. Do GP 6.7 to install a supply spool.
6. Program the printer to feed a book job into the eWire and confirm
that the eWire successfully creates a book.
7. Verify the quality of the book, including appropriate roundness of
the bound element. If there is a concern about binding quality,
refer to the troubleshooting guide found in Section 3, Book Quality.
Installation Instructions 01/26/2018
8-12
GBC eWire