Rep 2.22 Steering Motor Replacement, M16 And M17 - GBC eWire Service Manual

Installation Procedure
1. Slide the new Steering Module Assembly into the Lower Bypass,
aligning the M4 screw holes.
2. Tighten the M4 Screws on the front frame (4) and rear frame (3) to
secure the Steering Module.
3. Re-connect the cables to the Steering Module.
4. Re-connect the Ground Strap.
5. Do REP 1.1 Top Cover Replacement
6. Connect the Power Cord.
7. Power ON the eWire.
Repairs/Adjustments
to install the Top Cover.

REP 2.22 Steering Motor Replacement, M16 and M17

PARTS LIST ON PL 5.3
Use the following procedures to remove and install the Steering Stepper
Motors (M16 and M17)
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Do REP 2.21 Steering Module Replacement
Module.
4. Do REP 2.2 Drive Roller Replacement – Steering Module
the Steering Drive Roller corresponding to the motor you are
replacing.
5. Remove the Pulley from the motor shaft by loosening the set screw.
Set aside the Pulley and Drive Belt.
6. Disconnect the Motor Cable from the corresponding Stepper Driver
Board.
7. Disconnect the Motor by removing the M3 Screws (4), and remove
the Motor from the Steering Module.
01/26/2018
4-42
to remove the Steering
to remove
GBC eWire