Check S6-S10, S12, S13, And S15; General Procedures And Information - GBC eWire Service Manual

GP 6.4.2

Check S6-S10, S12, S13, and S15

Use the information in this section to locate the appropriate sensor(s) on
the eWire. Once you have located the sensor, follow
the function of the sensor. If the sensor does not operate as expected,
follow the troubleshooting steps located in this section to fix the faulty
sensor.
Locate Sensors S12, S13, and S15:
•
Raise the Top Cover.
•
Locate the Alignment Sensor Board openings on the Upper
Bypass panel frame.
•
The sensors are mounted on a common Board, but can be
checked individually.
•
Sensors S11 and S14 are located on the Alignment Sensor
Board, but are not used with eWire.
Sensors S12, S13, and S15 are located on the Alignment Sensor
Board
GBC eWire
Locate Sensors S6, S7, S8, S9, and S10:
GP 6.3.2 to verify
Sensors S6, S7, S8, S9, and S10 are on the Skew Sensor Board
01/26/2018
6-23
•
Raise the Top Cover
•
Locate the Skew Sensor Board on the surface of the
Alignment Carriage.
•
Sensors S6-S10 can be checked by sliding a piece of paper
into the opening below the Skew Sensor PCB

General Procedures and Information