Rep 7.4 Front Tapper Spring Replacement - GBC eWire Service Manual

Installation Procedure
1. Place the new Sensor onto the Tapper Frame, using the cutout
for alignment.
2. Secure the sensor by tightening the M3 screw
3. Connect the Sensor Cable.
4. Do REP 7.1 Front Tapper Assembly Replacement
Front Tapper Assembly.
5. Connect the Power Cord
6. Turn on the eWire.
GBC eWire

REP 7.4 Front Tapper Spring Replacement

PARTS LIST ON PL 5.17
Use this procedure to remove and install the Extension Spring on the
Front Tapper Assembly. Note: The same procedure can be used to
replace the spring on the Rear Tapper Assembly.
Removal Procedure
to install the
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Do REP 7.1
Front Tapper Assembly
4. Remove the Spring by removing one end from the notch on the
Tapper Frame and the other end from the mounting Screw on the
Tapper Finger Assembly
Installation Procedure
1. Reverse the steps from the Removal Procedure.
01/26/2018
4-141
WARNING
Front Tapper Assembly Replacement to remove the
Repairs/Adjustments