GBC eWire Service Manual page 285

4. Locate the female half of the Latch on the bracket near the back of
the Frame. Remove the Latch by removing the M3 Screws (4).
Installation Procedure
1. Install the new Latch to the frame and secure it using the M3 Screws
(4). Install the new Latch to the Element Feeder Drawer and secure it
using the M4 Screws (2).
2. Adjust the latch position so that the latch fits together easily. Tighten
the screws when latch is properly located.
3. Connect the Power Cord.
4. Turn on power to the eWire.
GBC eWire
REP 9.6 Stepper Driver Boards Replacement, M3, M5, M15 & M21
Use this procedure to remove and install the Stepper Driver Boards for
motors M3, M5, M15 and M21.
Removal Procedure
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Press the Power switch to OFF position.
2. Disconnect the Power Cord.
3. For M3, M15 and M21, do REP 1.5
remove the Back Cover. For M5, do REP 1.6
Replacement to remove the Side Cover.
4. Note the wire connection locations on the back of the Switch.
5. Disconnect the Cables from the appropriate Stepper Driver.
01/26/2018
4-169
WARNING
Back Cover Replacement
Side Cover
Repairs/Adjustments
to