Rep 1.11 Caster Replacement - GBC eWire Service Manual

REP 1.11 Caster Replacement

PARTS LIST ON PL 5.1
Use this procedure to replace the Caster Assembly.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire
2. Disconnect the Power Cord.
3. Carefully lift the corner of the eWire nearest the Caster. Support the
eWire so that the machine is secured when Caster is removed.
4. Do REP 1.6 Side Cover Replacement
nearest the Caster.
5. Loosen the Jam Nut
Repairs/Adjustments
to remove the Side Cover
Jam Nut
Caster
6. Remove the M5 Mounting Screws (4) to remove the Caster Plate. The
Caster Assembly can be lifted up through the Frame.
7. Place the new Caster in position and screw it in.
8. Tighten the Jam Nut.
9. Lower the eWire
10. Do REP 1.6 Side Cover Replacement
11. Connect the Power Cord.
12. Power ON the eWire.
01/26/2018
4-14
to install the Side Cover.
GBC eWire