GBC eWire Service Manual page 167

7. Disconnect the 4 Sensor Cables that run to the Element Feed Track
Assembly. Note that the Header is fixed and the Sensor Cables can
be removed from the Header by tugging gently on the cables.
8. Remove the Feed Track from the Element Feeder by removing the
M4 Screws (3).
GBC eWire
9. Locate the Receiver PCB on the back of the Track Assembly.
Remove the M2 Screws (2) to remove the Receiver PCB.
10. Remove the M2 Screws (2) to remove the Emitter PCB.
01/26/2018
4-51
Repairs/Adjustments