Rep 8.5 Holder At Reverse Gate Sensor S39 - GBC eWire Service Manual

Installation Procedure
1. Install the new Sensor by tightening the M3 Screw. Use tab for
alignment.
2. Connect the Sensor Cable.
3. Do REP 1.5 Back Cover Replacement
4. Connect the Power Cable
5. Turn power ON to the eWire.

REP 8.5 Holder at Reverse Gate Sensor S39

PARTS LIST ON PL 5.20
GBC eWire
to install the Back Cover.
01/26/2018
4-147
Use this procedure to remove and replace the Holder at Reverse Gate
Sensor S39.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Turn off Power to the eWire.
2. Disconnect the Power Cord.
3. Raise the Lid and Lower Bypass.
4. Locate the Holder at Reverse Gate Sensor. Refer to PL 5.20 and GP
6.4.3.
5. Disconnect the Sensor Cable.
6. Remove the Sensor by removing the M3 Screw.
Installation Procedure
Repairs/Adjustments