GBC eWire Service Manual page 444

20. Remove the foam shipping blocks from the front and rear that
keeping the holder in place.
21. Place the spare magnet strips from the installation kit on the
element feeder as shown below. When storing them on the
element feeder, ensure that they are completely on the flat face of
the drawer and are not near the spool.
GBC eWire
22. Take the wire cutters from the installation kit and install them into
the triangular pocket located behind the element feeder door.
Place the Element Height Setup Tool and the Punched Hole
Position check tool on the inside of the book drawer as shown
below. Secure the Element Height Setup Tool using the M4 screw
provided.
Element Height
Setup Tool
01/26/2018
8-7
Punched Hole
Position Tool
Installation Instructions