Rep 3.8 Element Feed Sprocket Motor Replacement, M9 - GBC eWire Service Manual

Installation Procedure
1. Insert the new Motor into the slots on the frame, and loosely attach
the M4 nuts (4) to secure it.
2. Slide the pulley onto the motor shaft, and adjust the pulley position
until the belt has proper tension. Tighten the mounting screws to
secure the motor.
3. Tighten the Pulley to the motor shaft by securing the set screw.
4. Connect the Motor cables to the Stepper Motor Driver.
5. Re-attach all covers by reversing the steps in the Removal
Procedure.
6. Connect the Power Cord.
7. Power ON the eWire.
GBC eWire

REP 3.8 Element Feed Sprocket Motor Replacement, M9

PARTS LIST ON PL 5.8
Use this procedure to remove and install the Element Feed Belt Sprocket
Stepper Motor.
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
Removal Procedure
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Open the Front Door and slide out the Element Feeder drawer.
4. Do GP 6.8 to remove the Supply Spool.
5. Remove the Rear Cover by removing the M4 Screws (8)
01/26/2018
4-59
WARNING
Repairs/Adjustments