GBC eWire Service Manual page 404

GP 6.6.2 Check L5 Deflector Solenoids
Locate Solenoid L5:
•
Raise the top cover by releasing the latch and raise the Lower
Bypass Assembly by lifting the handle.
•
Raise the Vacuum Module to access the Deflector
•
Insert a cheater into the Lid Interlock
•
There are two L5 solenoids located on the deflector module, refer
to PL 5.16. The Deflector will raise and lower when L5 is
activated.
Moving Parts, keep hands clear of moving parts when
the Interlock Cheater is inserted. See Section 0, page
vii for other languages.
1. Do GP 6.3.4 SOLENOIDS Procedure
Solenoid L5
•
The deflector mechanism should pivot when solenoid L5 is
activated.
•
Look carefully to confirm that the front and rear Deflector
Solenoids are both firing simultaneously.
GBC eWire
WARNING
to activate and deactivate
Deflector mechanism pivots when L5 is activated
Yes- Return to the RAP that directed you here
No- Go to Step 2
2. Make sure the solenoid wire is connected securely at the header and
at the Main Control Board (PL 5.27). Do REP 1.5 to remove the Rear
Cover to gain access to the connector at the Control Board. Refer
to GP 6.26 for termination locations.
All the connectors are securely connected.
Yes- Go to Step 3
No- Make the connection and resume operation
3. Check that the cable(s) connecting the Solenoid to the Main Control
Board are intact. Refer to the solenoid cables table
identify the appropriate cable part numbers.
The cables look okay
Yes- Go to Step 4
No- Identify and replace the faulty cable
4. Do 6.3.7 FIRMWARE UPGRADE Procedure
for the eWire
This clears the fault
Yes- Return to normal operation
No- Go to Step 5
5. Replace 7718113 Deflector Solenoid Linkage, refer to REP 5.6
This clears the fault
Yes- Return to normal operation
No- Go to Step 6
6. Do REP 11.1 Main Control Board A Replacement.
This clears the fault
Yes- Return to normal operation
No- Escalate to second level
01/26/2018
6-53
GP 6.26
to Re-flash the firmware
General Procedures and Information
to