Rep 5.6 Deflector Module Timing Belt Replacement - GBC eWire Service Manual

REP 5.6 Deflector Module Timing Belt Replacement

PARTS LIST ON PL 5.16
Use this procedure to remove and install Deflector Timing Belt
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
Removal Procedure
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Do REP 5.1 Deflector Module Replacement
Module.
4. Do REP 5.5 Bind Path Motor Replacement
5. Slide the old Timing Belt off of the Drive Pulley and remove it.
Repairs/Adjustments
to remove the Deflector
to remove the Motor.
Installation Procedure
1. Loosely slide the new Timing Belt around the Drive Pulley
2. Do REP 5.5 to reinstall the Motor.
3. Check the Belt tension. If necessary, increase or decrease tension in
the Belt by reseating the Motor.
4. Do REP 5.1 Deflector Module Replacement
Module.
5. Connect the Power Cord.
6. Power ON the eWire.
01/26/2018
4-122
to Install the Deflector
GBC eWire