GBC eWire Service Manual page 409

12. Turn the rewind spool clockwise until you have enough wire to reach
the blue wire guide. Slide the wire onto the plastic wire guide and
feed it into the plastic sprocket. Use the knob to manually turn the
plastic sprocket and aid wire installation
13. Adjust the wire end position by using the knob attached to the wire
feed sprocket. The wire end should line up in the window on the blade
guard.
General Procedures and Information
14. Confirm that the spool is installed properly.
a. Is the rewind paper secured to the Rewind Hub and taut?
b. Is the wire fed loosely across the wire shield?
c. Is there one row of slack wire beneath the spool, in contact
with the bottom of the Element Feeder Drawer?
d. Is the end of the wire in line with the mark on the Element
Guide Nose, just in front of the Knife?
e. Is all the spool packaging and the flexible magnet removed?
15. Slide the Element Feeder Drawer back into the eWire and close the
door.
01/26/2018
6-58
GBC eWire