Book Drawer; Rep 10.1 Drawer Full Up Sensor Replacement - GBC eWire Service Manual

10. Book Drawer

REP 10.1 Drawer Full Up Sensor Replacement

PARTS LIST ON PL 5.23
Use this procedure to remove and install the Book Drawer Full Up
Sensor. There are two sensors, each consisting of two halves.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Pull the Book Tray all the way out of the eWire.
4. Do REP 1.7 to remove the Book Drawer Door.
5. The emitter PCB (2) is located on the front of the Book Drawer.
Disconnect the Emitter PCB Cable.
6. Remove the emitter PCB (2) by pulling it away from the book drawer.
The emitter PCB is attached by snap-type standoffs.
7. Remove the cover from the back of the Book Drawer by removing the
M4 Screws (4).
8. Disconnect the receiver PCB cable.
9. Remove the receiver PCB (2) by pulling it away from the book drawer.
The PCB is attached by snap-type standoffs.
Repairs/Adjustments
Installation Procedure
1. Snap the new Reciever PCB and Emitter PCB onto the respective
snap-on standoffs.
2. Connect the Emitter and Receiver PCB sensor cables.
3. Reverse the procedure from the Removal Procedure to reconnect all
covers.
4. Connect the Power Cord
5. Turn power ON to eWire.
01/26/2018
4-174
GBC eWire