Adj 1.12 Caster Height Adjustment - GBC eWire Service Manual

11. Before tightening the collar, using a hex key, apply counter-clockwise
torque to the collar. This ensures that there is no slack on the top
section of the chain. While holding the chain taught, secure the M4
set screw.
12. Close the machine and run a book to examine the bind. If the problem
is still present repeat steps 2-7.
13. Reinstall the closer covers removed in step 1.
14. Return to the RAP that directed you here.
Repairs/Adjustments

ADJ 1.12 Caster Height Adjustment

Use the following procedure to adjust the height of the eWire.
Adjustment Procedure
1. Remove the screw securing the docking bracket between the
eWire and the upstream punch and disengage the bracket.
2. Refer the manual of the downstream device and disengage the
docking mechanism between it and the eWire. Adjusting the
height of the eWire with docking brackets engaged can damage
the docking mechanisms.
3. Perform REP 1.5 to remove the Back Cover to gain access to the
rear casters.
4. The front casters can be accessed by opening the Element
Feeder and the Book Drawer doors. To reach the caster you must
pull out the drawer completely and access the caster behind it.
Do not pull out both drawers at the same time, this will block
access to both casters.
5. Loosen the M12 Jam Nut on the caster or casters that require
adjustment. Do not remove the Jam Nut completely.
01/26/2018
4-202
GBC eWire