Punched Hole Specifications - GBC eWire Service Manual

5. If sheets are being fed from a separate device downstream
of the printer (i.e. an inserter), verify correct punched hole
positions on those sheets as well. Refer to the
AdvancedPunch Pro Service Manual to correct any issues
before proceeding.
6. If using tabs or clear covers, verify correct punched hole
positions on those sheets as well. Refer to the
AdvancedPunch Pro Service Manual to correct any issues
before proceeding.
7. If the backgauge, alignment, and skew are set correctly on
the AdvancedPunch Pro for all media being used return to
the troubleshooting procedure that guided you here. Note
that if a different die is used or if the docking position of the
AdvancedPunch Pro is changed these steps may need to
be repeated.
GBC eWire
3.2.1

Punched Hole Specifications

A) A4 Alignment = 6.3mm
LTR Alignment = 6.0mm
B) Back gage = 1.85mm
C) Hole Diameter = 5mm
D) Hole length and width = 5mm
02/20/2018
3-5
Punch Quality