GBC eWire Service Manual page 412

11. Remove the spool from the machine. Pull the spool straight away
from the machine to slide it off the spindle. Properly store the spool
for future use. Refer to GP 6.9
12. To remove the rewind spool from the feed spindle, push the hub in
and turn it clockwise. Remove the excess paper by sliding it off the
hub. If the rewind spool is full of paper, it may be difficult to remove.
The spool must be pressed in firmly before rotating to disengage the
pin. Reinstall the empty Paper Feed Hub onto the spindle.
GBC eWire
for Spool Storage guidelines.
13. Open the top cover and identify the wire Holder. Check if there is a
cut length of wire on the Holder (long boxed section). If there is,
remove it by pressing the Holder release (small boxed sections) and
removing the wire.
14. If a new supply spool is to be installed, refer to GP 6.7. If not, reinstall
the Spool Holder Cap and Wire Guide for the next operation.
15. Slide the Element Feeder Drawer back into the eWire and close the
door.
01/26/2018
6-61
General Procedures and Information