Rep 10.2 Drawer Full Down Sensor Replacement S43 - GBC eWire Service Manual

REP 10.2 Drawer Full Down Sensor Replacement S43

PARTS LIST ON PL 5.23
Use this procedure to remove and install the Book Drawer Full Down
Sensor.
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
Removal Procedure
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Slide the Book Drawer Tray all the way out of the eWire.
4. Remove the Book Drawer rear cover by removing the M4 Screws (4).
5. Disconnect the Sensor cable from the Sensor.
6. Remove the sensor bracket by removing the Screws (2).
7. Disconnect the Sensor from the bracket by removing the M3 Screw
and remove the old sensor.
GBC eWire
Installation Procedure
1. Reverse the Steps from Removal Procedure.
2. Connect the Power Cord
3. Turn power ON to eWire.
01/26/2018
4-175
Repairs/Adjustments