Rep 3.7 Element Feed Belt Motor Replacement, M10 - GBC eWire Service Manual

11. Remove the Element Feeder Belt.
Installation Procedure
1. Reverse the steps in the Removal Procedure.
2. Do GP 6.8 to install the supply spool.
3. Connect the Power Cord.
4. Power ON the eWire.
GBC eWire

REP 3.7 Element Feed Belt Motor Replacement, M10

PARTS LIST ON PL 5.8
Use this procedure to remove and install the Element Feed Belt Stepper
Motor.
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
Removal Procedure
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Open the Front Door and slide out the Element Feeder drawer.
4. Do GP 6.8 to remove the Supply Spool.
5. Remove the Upper Element Feeder Cover by removing the M4
Screws (2)
01/26/2018
4-57
WARNING
Repairs/Adjustments