Rap 5.13 J383- Full Open Timeout - GBC eWire Service Manual

RAP 5.13 J383- FULL OPEN TIMEOUT
J383 is triggered if it takes longer than specified time for a change of state
at S47 Closer Full open sensor to indicate the closer jaws are fully open
just before book eject.
1. Do GP 6.4 to check S47 Closer full open sensor
This clears the fault
Yes- Return to normal operation;
No- Go to Step 2
2. Do GP 6.5 to check M20 Element Closer motor
This clears the fault
Yes- Return to normal operation;
No- Go to step 3
3. Do REP 6.1 to remove the Closer module.
If the closer jaws are jammed-The closer cam drive for the closer jaws
is difficult to rotate manually by hand. The easiest way to clear a
jammed closer jaw mechanism is by removing (5) M5 screws of the
Closer motor, removing the closer motor and manually turning the
mechanism. Do not leave the cam in the dwell position, any other
position is acceptable.
4. Check if the set screw on the Closer motor gear and the screws in the
drive components are sufficiently tight.
The screws are tight
Yes- Go to Step 5;
No- Tighten the loose set screw(s) and resume operation
GBC eWire
5. Check the Condition of the Closer cam chai.
The chain is in good condition.
Yes- Go to Step 6;
No- Replace the damaged chain and resume operation
6. Inspect the cam follower. If it appears to be damaged or missing,
replace it.
Cam follower is in good condition
Yes- Go to Step 7;
No- Replace the Closer Module REP 6.1
7. Ensure the sheet metal feature properly blocks/unblocks S47 Closer
full open sensor
The sheet metal feature properly blocks/unblocks the sensor
Yes- Go to Step 8;
No- Position the disc correctly
01-26-2018
2-64
RAPS