Remove The Packing Materials - GBC eWire Service Manual

8.3. Remove the Packing Materials

Do the following to remove all packing materials from the eWire.
1. Clear the space needed for the eWire.
2. Move the Shipping Container into position near where you will
install the eWire
3. Remove the plastic shrinkwrap from the container and remove the
Packing Straps.
4. Remove the wooden ramp from the top of the Shipping Container.
Do not discard the wooden ramp. It will be needed later to remove
the eWire from the pallet.
5. Remove the foam corner protectors from inside the packaging.
6. Remove cardboard outer package by lifting it straight up off the
eWire. Take care not to scrape the sides of the machine. Note:
Two people should work together to lift the outer packaging, which
is one large piece.
7. Remove the inner shrink wrap covering the eWire.
Installation Instructions
8. Locate the 4 Support Brackets on the front and back of the
machine. Remove the M6 Screw securing the Clamp to the
Support Bracket and remove the Clamp. Remove the M10 Screws
securing the Support Bracket and remove the Support Bracket
from the eWire.
9. Repeat for the remaining Support Brackets and Bracket Clamps.
10. Remove the M6 Screws securing the Side Bracket to the eWire.
Remove the M10 Screws securing the Side Brackets to the pallet.
Slide the Side Brackets out from under the eWire and remove it.
11. Repeat for the opposite Side Bracket.
01/26/2018
8-4
GBC eWire