GBC eWire Service Manual page 169

4. Remove the M2 Screws (2) to remove the Receiver PCB.
5. Peel back the Protective Tape holding the Sensor Cables to the rear
of the Track and remove the Cables.
GBC eWire
Installation Procedure
1. Take care when handling the Emitter and Receiver PCBs as the wires
can be damaged if too much force is applied.
2. Install the new Receiver and Emitter PCBs onto the Element Home
Sensor Mounting Bracket by using the M2 Screws.
3. Run the Sensor Cables along the back of the Track and hold the
cables in place using protective Tape.
4. Reverse the steps from the Removal Procedure to install the
remaining Element Feeder parts.
5. Connect the Power Cord.
6. Power ON the eWire.
01/26/2018
4-53
Repairs/Adjustments