Rep 3.15.7 Pushover Motor Assy Replacement M12 - GBC eWire Service Manual

REP 3.15.7 Pushover Motor Assy Replacement M12

PARTS LIST ON PL 5.13
Use this procedure to remove and install the Expanding T Pushover
Motor Subassembly.
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
Removal Procedure
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Do REP 3.15 Element Transfer Module Replacement
Element Transfer Module.
4. Do REP 3.15.1 Element Pushover Encoder Sensor Replacement S31
to remove the Pushover Encoder Sensor and the Encoder Sensor
mounting bracket.
5. Do REP 3.15.5 Horizontal Pushover Cam Replacement
Horizontal Pushover Cam on the drive side.
6. Remove the M4 Flat Head Screws securing the top of the Pushover
Motor Bracket Assembly.
GBC eWire
7. Remove the M3 Screw securing the side of the Pushover Motor
Bracket Assembly.
to remove the
8. Carefully remove the Pushover Motor Bracket Assembly from the
to remove the
frame.
9. Remove the flanged bearing from the drive shaft and remove the
Timing Belt from the Motor Drive Pulley. Set the parts aside.
01/26/2018
4-89
Repairs/Adjustments