8.1. Introduction
This section contains general installation points regarding the unpacking
and setup of the eWire.
8.1.1 Check the Packing List
The eWire shipping material should contain 2 boxes:
•
Pallet with eWire.
•
Cardboard box containing the Spare Parts Kit.
The fully packed eWire measures 1270mm H x 1040mm W x 920mm L
(50in H x 41in W x 36 in L) and weighs 274 kgs (605 lbs)
GBC eWire
8.2. Installation Requirements
8.2.1 Space Requirements
Before installing the eWire, make sure you have adequate space and
clearance.
EWire System Dimensions
8.2.2 Upstream Device Requirements
The AdvancedPunch Pro punch system must be installed upstream of
the eWire. The AdvancedPunch Pro does not need to be directly
attached to the eWire.
8.2.3 Required Tools
The following tools are required to unpack and install the eWire.
•
Utility knife or box cutter
•
17mm and 19mm open end wrenches
•
10mm socket wrench
•
7mm socket wrench or nut driver
•
200 gsm (or heavier) paper
01/26/2018
8-3
Installation Instructions